Table of Contents
Advertisement
Faults
Malfunction indicator lamp
lights up
The ABS indicator lamp lights
up
High oil consumption
The battery is discharged
Possible cause
Fault in fuel injection system
ABS fuse is blown
Wheel speeds of front and rear
wheels differ greatly
Malfunction in ABS
Engine oil level too high
Engine oil too thin (low viscos-
ity)
A power consumer is connected
to the socket/ACC1.
The hazard warning flasher is
switched on
Battery is not charged by alter-
nator
Ignition was not switched off
when vehicle was parked
TROUBLESHOOTING 22
Action
–
Read out the fault memory using the
KTM diagnostics tool.
–
Change the fuses in the fuse box.
(
p. 264)
–
Stop, switch off the ignition, start
again.
–
Read out the fault memory using the
KTM diagnostics tool.
–
Check the engine oil level. (
–
Change the engine oil and oil filter and
clean the oil screens.
(
–
Disconnect the power consumer from
the socket/ACC1.
–
Recharge the battery.
(
–
Switch off the hazard warning flasher.
–
Recharge the battery.
(
–
Check the charging voltage.
–
Recharge the battery.
(
p. 279)
p. 280)
p. 255)
p. 255)
p. 255)
301
Advertisement
Table of Contents
