Table of Contents
Advertisement
Setup
The setup of the Switch can be performed using the following
steps:
♦ The surface must support at least 5 kgs.
♦ The power outlet should be within 1.82 meters (6 feet) of the
device.
♦ Visually inspect the power cord and see that it is secured fully
to the AC power connector.
♦ Make sure that there is proper heat dissipation from and
adequate ventilation around the Switch. Do not place heavy
objects on the Switch.
Desktop or Shelf Installation
When installing the Switch on a desktop or shelf, the rubber feet
included with the device must be first attached. Attach these
cushioning feet on the bottom at each corner of the device. Allow
enough ventilation space between the device and the objects
around it.
Figure 2-1. Gigabit Ethernet Switch installed on a Desktop or Shelf
7
Advertisement
Table of Contents
