Setup > Wireless; Wireless Interface - D-Link SECURICAM DCS-910 User Manual

Section  - Configuration
In this section, you can setup and configure the wireless
settings on your camera.
Note: Wireless is available only for the DCS-920.
SSID:
Service Set Identifier, an identifier for your wireless network.
Channel:
The default setting is channel 6. Select the same channel that is using by other wireless devices within your network. When there is
interference from the wireless networks that overlap with one another, you may change the channel to obtain maximum performance
for your connection.
Connection Mode:
Infrastructure is a wireless connection using an access point as a transmission point of all wireless devices. Ad-Hoc is a wireless
connection used without an access point, where your DCS-920 is directly connecting to your PC. This is done using the on-board
wireless adapter on the DCS-920 connected to a wireless adapter on the PC.
Site Survey:
This page will allow you to select a wireless network that the DCS-920 was able to detect upon booting up.
WPS: This option will allow you to run the Wi-Fi Protected Setup directly from your DCS-920 Web GUI.
Wireless Security
For security, there are three choices; None, WEP, and WPA-PSK / WPA2-PSK. Select the same encryption method that is being
Mode:
used by your wireless device/ router.
An appropriate Preshared Key, which is needed in order to connect to the wireless network..
WPA-PSK / WPA2PSK
Settings:
D-Link DCS-910/90 User Manual
Setup > Wireless

Wireless Interface

9