D-Link SECURICAM Network DCS-5300W Manual page 41

Using the DCS-5300W with an Internet
browser (continued)
Configuration > Advanced >Network Settings (continued)
Channel -
TX Rate-
Preamble-
Data Encryption
Auth mode -
Open Authentication -
Shared Authentication -
Auto -
Key type -
Key Format -
Key Index -
Click Apply to make
changes effective
The default wireless channel setting is channel
6. Select the channel that is the same as the
other wireless devices on your network.
Select the transmission rate on the network.
22 Mbps is the default setting.
Select Long or Short Preamble. The Preamble
defines the length of the CRC block (Cyclic
Redundancy Check is a common technique for
detecting data transmission errors) for
communication between the Access Point and
the roaming wireless Network adapters. Long
Preamble is the default setting. Note: High
network traffic areas should use the shorter
preamble type.
- Enable Encryption by clicking on the box. The
DCS-5300W has Encryption disabled as the
default setting.
Choose one of the following authorization
modes:
Communicates the key across the network.
Allows communication only with other devices
with identical WEP settings.
Will automatically adjust to the Authentication
mode of the wireless client.
Select the key length, either 64, 128 or 256 bits.
Select an ASCII or hexadecimal key format.
You can create up to 4 different security keys.
41