D-Link SECURICAM Network DCS-5300W Manual page 14

Installation Wizard (continued)
The Installation Wizard will now show a MAC address for the DCS-5300W
and an IP address. This IP address may not be correct at this step in the
installation until you see "Yes" under the assigned column. The camera is now
automatically configured with an IP address consistent to the device it is
connected to.
Select the MAC address.
Click on the Link to Selected
Devices button.
For more information regarding the functions of this screen, see the following
section titled "Installation Wizard Screen."
After you click on the Link
to Selected Devices
button, Installation
Wizard will automatically
open your
browser to the IP Ad-
dress of the DCS-5300W
in this example it is: http:/
/192.168.0.146. Your
DCS-5300W may have a
different IP Address.
You have now completed the Setup Wizard and are ready to use your
camera! You can also continue to the section titled "Installing IP
surveillance Software" to install the IP surveillance software before you
begin to use the DCS-5300W.
Internet
14
192.168.0.146 DCS-5300W