Weekly Schedule; Event Operation - D-Link SECURICAM Network DCS-3220G Manual

Using the DCS-3220G with an Internet
browser (continued)
Configuration > Tools > Applications (Continued)

Weekly schedule:

Sunday through Saturday -
Snapshots begin at -
Snapshots stop at -
All the time except for the
above schedule -
Snapshot Interval -
snapshot.

Event operation:

Delay second(s) before
detecting next event -
Take snapshots at
second(s) after event -
Trigger condition -
Select the weekdays that should perform the
following operations:
Set the time to start operations. Setting the begin
time the same as the stop time will force the
operations to run continuously.
Sets the time to stop the operations.
If you do not wish to set a schedule, this box
must be checked.
Interval of time between each sequential
Sets the time delay before restarting to check the
trigger condition when the current condition is
triggered.
After a snapshot is taken because of a trigger,
another snapshot will be taken after the
configured time in seconds.
There are 4 conditions related to the digital input
and three windows for motion detection. There
can be multiple selections. Select the appropriate
digital input condition according to the
characteristics of the external device. High or low
indicate external voltage input for level trigger,
while rising or falling is for edge triggers. There
are three windows shown for the names you
defined for motion detection. Undefined will
show instead of the window title if motion
detection is not setup yet. An active, named
motion window must be checked for motion
detection to be possible.
56