Table of Contents
Advertisement
www.aeg.com
4
Water connection
• Do not connect the appliance with old
hoses already used. Only use new ho-
ses.
• Make sure not to cause damage to the
water hoses.
• Do not connect the appliance to new
pipes or pipes not used for a long
time. Let the water flow for some mi-
nutes, then connect the inlet hose.
• The first time you use the appliance,
make sure that the water hoses and
the couplings do not have leakages.
Electrical connection
• Make sure that the appliance is earth-
ed.
• Make sure that the electrical informa-
tion on the rating plate agrees with
the power supply.
• Always use a correctly installed shock-
proof socket.
• Do not use multiple plugs and exten-
sion cables. There is a risk of fire.
2. TECHNICAL INFORMATION
Dimensions
Electrical connection:
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, ex-
cept where the low voltage equipment has no pro-
tection against moisture
Water supply pressure
Water supply
Maximum load
Spin speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Width / Height / Depth
Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
1)
Cotton
Maximum
• Do not replace or change the mains
cable. Contact the service centre.
• Make sure not to cause damage to the
mains plug and cable.
• Connect the mains plug to the mains
socket only at the end of the installa-
tion. Make sure that there is access to
the mains plug after the installation.
• Do not pull the mains cable to discon-
nect the appliance. Always pull the
mains plug.
1.5 Discard the appliance
Disconnect the mains plug from the
1.
mains socket.
2.
Cut off the mains cable and discard
it.
3.
Discard the door catch. This pre-
vents children or pets to be closed
in the appliance. There is a risk of
suffocation (only for front-loading
appliances).
600 / 850 / 430 mm
487 mm
230 V
2000 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
6.5 kg
1200 rpm
Advertisement
Table of Contents
