AEG L 76475 FL User Manual
Hide thumbs
Also See for L 76475 FL:
- User manual (2 pages) ,
- User manual (56 pages) ,
- User manual (68 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for AEG L 76475 FL
Summary of Contents for AEG L 76475 FL
- Page 1 EN User manual L 76475 FL L 76675 FL...
-
Page 2: Table Of Contents
13. INSTALLATION ............25 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler –... -
Page 3: Safety Information
ENGLISH 1. SAFETY INFORMATION Before the installation and use of the appliance, careful- ly read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use cau- ses injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability. -
Page 4: Safety Instructions
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali- fied persons in order to avoid a hazard. • The operating water pressure (minimum and maxi- mum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) •... -
Page 5: Technical Information
ENGLISH Water connection • Do not put a container to collect pos- sible water leakage under the appli- • Make sure not to cause damage to the ance. Contact the Service to ensure water hoses. which accessories can be used. •... -
Page 6: Product Description
Maximum load Cotton 7 kg Spin speed Maximum 1400 rpm (L 76475 FL) 1600 rpm (L 76675 FL) 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 4. PRODUCT DESCRIPTION Worktop Feet for the appliance level... -
Page 7: Control Panel
ENGLISH 4.1 Accessories Spanner To remove the transit bolts. Plastic caps To close the holes on the rear side of the cabinet after the removal of the transit bolts. Anti-flood inlet hose To prevent possible leakage Plastic hose guide To connect the drain hose on the edge of a sink. -
Page 8: Programme Knob
• After 5 minutes from the end of the 5.2 Programme knob washing programme. Refer to 'At the end of programme'. Turn this knob to set a programme. The related programme indicator comes on. 5.3 Display The display shows: •... -
Page 9: Delay Start Button
ENGLISH • The programme time When the programme starts, the time decreases with steps of 1 mi- nute. • The delay start When you press the delay start button, the display shows the delay start time. • Alarm codes If the appliance has a malfunction, the display shows alarm codes. Re- fer to 'Troubleshooting' chapter. -
Page 10: Programmes
10 www.aeg.com • To activate the function, press button Spin phase is off. and button at the same time until the display shows the symbol 'Rinse Hold' function is • To deactivate the function, press but- and button at the same time until the symbol goes off. - Page 11 ENGLISH Programme Type of load Cycle Functions Temperature max. weight of load description Extra Stil White and coloured Wash FLECKEN 95° - Cold cotton with normal Rinses EXTRA SPÜLEN soil. Stop with water in ZEIT SPAREN max. 7 kg the drum Synthetica Synthetic or mixed Wash...
- Page 12 12 www.aeg.com Programme Type of load Cycle Functions Temperature max. weight of load description Gordijnen Set this programme Prewash SPIN REDUC- 40° - Cold to wash curtains. It Wash TION adds automatically Rinses RINSE HOLD the prewash phase to Short spin EXTRA SPÜLEN...
-
Page 13: Consumption Values
ENGLISH 6) Set this programme to decrease the time and the consumption of energy and water. 7) STANDARD PROGRAMMES for the Energy Label consumption values. According to regulation 1061/2010, these programmes are respectively the “standard 60° C cotton programme” and the “standard 40° C cotton programme” . They are the most efficient programmes in terms of combined energy and water consumption for washing normally soiled cotton laundry. -
Page 14: Before First Use
14 www.aeg.com Off Mode (W) Left-On Mode (W) 0.48 0.48 The information given in the charts above are in compliance with the EU Com- mission regulation 1015/2010 implementing directive 2009/125/EC. 8. BEFORE FIRST USE To activate the drain system, put 2 li- detergent dispenser. -
Page 15: Filling The Detergent And Additives
ENGLISH 9.2 Filling the detergent and additives The detergent compartment for the prewash phase, the soak programme and for the stain function. Add the detergent for prewash, soak and stain remover before the start of the programme. The detergent compartment for the washing phase. If you use a liquid detergent, put it immediately before you start the programme. - Page 16 16 www.aeg.com To use powder detergent, turn the flap up. To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid deter- gent than the limit showed in the flap.
-
Page 17: Open The Door
ENGLISH If you deactivate the appliance, it Press button . The indicator is necessary to set the pro- flashes. gramme again. Change the function set. 9.10 At the end of the 9.7 Set the delay start programme Press button again and again un- •... -
Page 18: Hints And Tips
18 www.aeg.com 10. HINTS AND TIPS 10.1 The laundry load 10.3 Detergents and additives • Divide the laundry in: white, coloured, • Only use detergents and additives synthetics, delicates and wool. specially made for washing machines. • Obey the washing instructions that are •... -
Page 19: Care And Cleaning
ENGLISH Water hardness table Water hardness Level Type °dH °T.H. mmol/l Clarke soft 0-15 0-1.5 medium 8-14 16-25 1.6-2.5 10-16 hard 15-21 26-37 2.6-3.7 17-25 very hard > 21 > 37 >3.7 >25 11. CARE AND CLEANING WARNING! CAUTION! Do not use alcohol, solvents or chemical products. -
Page 20: Detergent Dispenser
20 www.aeg.com 11.6 Detergent dispenser To clean the dispenser: Press the lever. Pull the dispenser out. Remove the top part of the liquid additive compartment. Clean all the parts with water. Clean the dispenser recess with a brush. Put back the dispenser in the recess. - Page 21 ENGLISH To clean the drain pump: Open the drain pump door. Pull the flap out to remove it. Put a container below the recess of the drain pump to collect the water that flows out. Press the two levers and pull for- ward the drainage duct to let the water flow out.
-
Page 22: Emergency Drain
22 www.aeg.com Clean the filter under the water tap and put it back in the pump into the special guides. Make sure that you tighten correctly the filter to prevent leakages. Put the flap back and close the drain pump door. -
Page 23: Troubleshooting
ENGLISH Put the drainage duct back and close the Close the water tap. drain pump flap. Remove the water inlet hose When you drain the water with the emer- Put the two ends of the inlet hose in gency drain procedure, you must acti- a container and let the water flow vate again the drain system: out of the hose. - Page 24 24 www.aeg.com Problem Possible cause Possible solution The appliance The water drain hose is Make sure that the water drain does not drain the damaged. hose has no damages. water. The filter of the drain Clean the filter of the drain pump is blocked.
-
Page 25: Installation
ENGLISH Problem Possible cause Possible solution Leakages from the drain Make sure that the drain pump pump. filter is tight. The water drain hose is Make sure that the water inlet damaged. hose has no damages. You cannot open The washing pro- Let the washing programme the appliance gramme is in operation. - Page 26 26 www.aeg.com 13.2 Unpacking Use the gloves. Remove the external film. If necessary, use a cutter. Remove the cardboard top. Remove the polystyrene packaging materials. Remove the internal film. Open the door and remove all the items from the drum.
- Page 27 ENGLISH Put one of the polystyrene packag- ing elements on the floor behind the appliance. Carefully put down the appliance with the rear side on it. Make sure not to damage the ho- ses. Remove the polystyrene protection from the bottom. Pull up the appliance in vertical po- sition.
-
Page 28: Positioning And Levelling
28 www.aeg.com Put the plastic caps in the holes. You can find these caps in the user manual bag. – We recommend that you keep the packaging and the transit bolts for when you move the appliance. – If the appliance is delivered in the winter months when there are minus temperatures. - Page 29 ENGLISH CAUTION! Do not put cardboard, wood or equivalent materials below the appliance feet to adjust the level. 13.4 The inlet hose • Connect the hose to the appliance. Turn the inlet hose only left or right. Loose the ring nut to set it in the cor- rect position.
-
Page 30: Water Drainage
30 www.aeg.com 13.5 Water drainage There are different procedures to con- nect the drain hose: With the plastic hose guide. • On the edge of a sink. • Make sure that the plastic guide can- not move when the appliance drains. -
Page 31: Environment Concerns
ENGLISH • Directly to a built-in drain pipe in the room wall and tighten it with a clip. You can extend the drain hose to maximum 400 cm. Contact the service centre for the other drain hose and the extension. 14. - Page 32 www.aeg.com/shop...