BT 3010 Executive User Manual page 57

Diverse 3010 Executive
Diverse 3010 Executive – Edition 4 – 22 November '00 - 3509
Is the handset switched on?
The battery may be flat or dead.
Recharge or replace the battery.
Is the telephone line cord plugged into
the phone socket and the base station?
If other handsets are registered on the
base, the outside line may already be in
use. Wait until the call is finished and
try again.
Is the handset registered with the base
station? To register the handset, see
page 42. Is the power cable connected at
the base and the power switched on at
the wall socket?
If you press the
the base station is flashing, you will
hear four short beeps from the handset.
If you go out of range of a base station
for a long time while your handset is
switched ON, it may take more than
20 minutes to 'find' the base station
again when you come back within
range. However, by simply switching
the handset OFF for a moment, and
then ON again, it will find the base
station within a few seconds.
22/3/01 12:04 pm
button whilst
Page 53
The ringer volume may be set too low,
or switched off at the base station. To
adjust the ringer volume at the handset
or base station, see pages 33-34 or 35
respectively.
Is the telephone line cord connected
correctly? See pages 6 and 9.
You may be set to the wrong signalling
method. To change between TONE and
PULSE dialling, see 'Using your Diverse
3010 Executive with a switchboard',
page 47.
Are the handset batteries low? You will
hear a beep every 30 seconds.
You will hear four short beeps when you
press the button. Check you
are still in range of your base station.
Diverse is too close and is causing
interference. Move it further away.
53