Table of Contents
Advertisement
PCIEX16_2 Configuration [Auto]
This item allows you to configure the PCIe x16_2 device settings.
[Auto]
[X2 Mode]
[X4 Mode]
Intel LAN Controller [Enabled]
[Enabled]
[Disabled]
3.6.8
APM Configuration
ErP Ready [Disabled]
Allows BIOS to switch off some power at S5 to get the system ready for ErP requirement.
When set to [Enabled], all other PME options will be switched off.
Configuration options: [Enable(S4+S5)] [Enable(S5)] [Disabled]
3.6.9
Network Stack Configuration
The items in this menu allow you to configure Ipv4 / Ipv6 PXE support.
3.6.10
HDD/SSD SMART Information
This menu displays the SMART information of the connected devices.
3.6.11
USB Configuration
The items in this menu allow you to change the USB-related features.
The USB Devices item shows the auto-detected values. If no USB device is detected, the
item shows None.
USB Single Port Control
This item allows you to enable or disable the individual USB ports.
Refer to section 1.1.2 Motherboard layout for the location of the USB ports.
3-14
Automatically detects the device installed.
(1) When a device is installed in PCIe x1_2 or PCIEx1_3 slot, PCIe x16_2
only runs in X2 Mode.
(2) When there are no devices installed in PCIe x1_2 or PCIe x1_3 slot,
PCIe x16_2 can run in X4 Mode.
PCIe x16_2 only runs in X2 Mode. PCIe x1_2 and PCIe x1_3 are enabled.
PCIe x16_2 can run in X4 Mode. PCIe x1_2 and PCIe x1_3 are disabled.
Enables the Intel LAN controller.
Disables the controller.
Chapter 3: BIOS Setup
Hide quick links:
Advertisement
Table of Contents
