Using The Flash - FujiFilm X-A10 Owner's Manual

Using the Flash

Using the Flash
Use the built-in fl ash for additional lighting when shooting at night or indoors under low light.
1 Slide the N (fl ash pop-up) switch to raise the fl ash.
2 Select p FLASH SET-UP > FLASH MODE in the shooting menu. The options shown below will be
displayed; press the selector up or down to highlight an option and press MENU/OK to select.
Mode Mode
AUTO (AUTO FLASH) AUTO (AUTO FLASH)/ /
K K (RED EYE REDUCTION) (RED EYE REDUCTION) * *
N N (FORCED FLASH) (FORCED FLASH)/ /
L (FORCED FLASH) L (FORCED FLASH) * *
O (SLOW SYNCHRO) O
(SLOW SYNCHRO)/ /
M M (RED EYE & SLOW) * *
(RED EYE & SLOW)
l (2ND CURTAIN SYNC.) l
(2ND CURTAIN SYNC.)/ /
d (2ND CURTAIN SYNC.) d * *
(2ND CURTAIN SYNC.)
D D (COMMANDER)
(COMMANDER)
P P (SUPPRESSED FLASH) (SUPPRESSED FLASH)
* Red-eye removal is available in these modes when Intelligent Face Detection is active
(P 82) and red-eye removal is on (P 86). Red-eye removal minimizes "red-eye" caused
when light from the fl ash is refl ected from the subject's retinas as shown in the illustra-
tion at right.
The fl ash fi res when required. Recommended in most situations.
The fl ash fi res whenever a picture is taken. Use for backlit subjects or for natural coloration when
shooting in bright light.
Capture both the main subject and the background under low light (note that brightly lit scenes
may be overexposed).
The fl ash fi res immediately before the shutter closes.
The built-in fl ash can be used to control optional remote fl ash units.
The fl ash does not fi re even when the subject is poorly lit. A tripod is recommended.
Description Description
71