Denon AVR-X4500H Owner's Manual page 309

Contents Connections Playback Settings Tips Appendix
z1 During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.
z2 This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD or Dolby Atmos signal is played.
z3 This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS:X or DTS signal is played.
z4 This item can be selected when a DTS:X signal that is compatible with the Dialog Control function is input.
z5 This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z6 This item can be selected when Height, Ceiling or Dolby Atmos Enabled speakers are used.
z7 This item cannot be set when "Dynamic EQ" is set to "On". (v p. 187)
z8 This item cannot be set when "Center" is set to "None". (v p. 229)
z9 This item cannot be set when "Subwoofer" in the menu is set to "None". (v p. 229)
z10 This item cannot be set when Audyssey ® Setup (Speaker Calibration) has not been performed.
z11 This item cannot be selected when a DTS:X format with a sampling frequency of over 48 kHz is input.
z12 This item cannot be set when "MultEQ ® XT32" in the menu is set to "Off". (v p. 186)
z13 This item cannot be set when sound mode is "DTS Virtual:X" or sound mode that have "+Virtual:X" in the sound mode name.
z14 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
z15 This can be set when the LFE signal is included in the input signal.
z16 This setting is available when "Subwoofer Mode" in the menu is set to "LFE+Main". (v p. 237)
z17 This item can be set when "Front" is set to "Small" or "Subwoofer Mode" is set to "LFE+Main". (v p. 229, 237)
z18 This can be set if the input signal does not contain an Auro-3D signal or if the input Auro-3D signal does not contain Front Height channels.
309
Front panel Display Rear panel Remote Index