TP-Link Archer C8 User Manual page 12

Chapter 2
4 ) Turn on the modem, and then wait about 2 minutes for it to restart.
5 ) Turn on the router.
6 ) Verify that the hardware connection is correct by checking these LEDs.
Tips: If 2.4G/5G LED are off, press the WiFi button for about 2 seconds, and then check the LEDs again in a
few seconds.
2. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
IC:8853A-C8
FCC ID:TE7C8
• Method 2: Wirelessly
1 ) Find the SSID (Network Name) and Wireless Password printed on the label at
the back of the router.
2 ) Click the network icon of your computer or go to Wi-Fi Setting of your smart
device, and then select the SSID to join the network.
Computer
Connections are available
Wireless Network Connection
TP-LINK_XXXX
TP-LINK_XXXX_5G
Connect automatically
√
• Method 3: Use the WPS button
Wireless devices that support WPS, including Android phones, tablets, most USB
network cards, can be connected to your router through this method. (WPS is not
supported by iOS devices.)
Power
2.4G/5G
On
On
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:(1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Connect
Internet
On
Ethernet cable
Smart Device
< Settings Wi-Fi
Wi-Fi
CHOOSE A NETWORK...
TP-LINK_XXXX
TP-LINK_XXXX_5G
Other...
Connect the Hardware
8