Yamaha 2009 YZF-R1Y Owner's Manual page 34

INSTRUMENT AND CONTROL FUNCTIONS
Right
4
1. Engine stop switch "
2. Drive mode switch "MODE"
3. Start switch " "
Pass switch "PASS"
Press this switch to flash the head-
lights.
Dimmer switch "
Set this switch to "
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
1
Horn switch "
Press this switch to sound the horn.
2
Engine stop switch "
3
Set this switch to "
the engine. Set this switch to "
/ "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU12370
Start switch "
Push this switch to crank the engine
with the starter. See page 6-1 for start-
EAU12400
ing instructions prior to starting the en-
/ "
gine.
" for the high
The engine trouble warning light will
EAU12460
come on when the key is turned to "ON"
/ "
and the start switch is pushed, but this
does not indicate a malfunction.
". When re-
Hazard switch "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU12500
" turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
EAU12660
/ "
might be a traffic hazard.
" before starting
" to
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12711
"
Drive mode switch "MODE"
Do not change the D-mode while the
EAU41700 vehicle is moving.
Using this switch changes the drive
mode to "STD", "A", or "B" in the follow-
ing order:
STD → A → B → STD
4-18
"
WARNING
EAU12733
" posi-
ECA10061
EAU47494
EWA15340