Yamaha 2009 YZF-R1Y Owner's Manual page 26

INSTRUMENT AND CONTROL FUNCTIONS
When the key is turned to "ON", the ta-
chometer needle sweeps once across
the r/min range and then returns to zero
r/min in order to test the electrical cir-
cuit.
NOTICE
Do not operate the engine in the ta-
chometer red zone.
Red zone: 13750 r/min and above
4
Clock and stopwatch modes
1. Clock/stopwatch
To set the clock
1. Push the "SELECT" button and
"RESET" button together for at
least two seconds.
2. When the hour digits start flashing,
push the "RESET" button to set the
hours.
3. Push the "SELECT" button, and
the minute digits start flashing.
ECA10031 4. Push the "RESET" button to set
the minutes.
5. Push the "SELECT" button and
then release it to start the clock.
To display the stopwatch
To change the display to the stopwatch
mode, push the "SELECT" button and
"RESET" button together. To change
the display back to the clock mode,
push the "SELECT" button and "RE-
SET" button together; however, this is
not possible when the stopwatch is
counting.
Standard measurement
1
1. Push the "RESET" button to start
the stopwatch.
2. Push the "SELECT" button to stop
the stopwatch.
3. Push the "SELECT" button again
to reset the stopwatch.
4-10
Split time measurement
1. Push the "RESET" button to start
the stopwatch.
2. Push the "RESET" button or start
switch " " to measure split times.
Split times are displayed on the
odometer display for five seconds.
3. Push the "RESET" button or start
switch " " to display the final split
time or push the "SELECT" button
to stop the stopwatch and display
the total elapsed time.
Split time history
1. Coolant temperature display/air intake tem-
perature display
2. Stopwatch
1
2