Cadillac 2006 CTS Navigation System Manual page 95

Personalization Features
The following choices are available for programming:
Personalization Name
This feature allows you to type in a name that will
appear on the DIC display whenever the corresponding
remote keyless entry transmitter is used or one of
the buttons on the driver's door armrest (1 or 2) is
pressed.
If a customized name is not programmed, the system
will show Driver 1 or Driver 2 to correspond with
the numbers on the back of the remote keyless entry
transmitters.
To program a name, do the following:
1. Enter the Personalization menu following the
instructions listed previously.
2. Turn the TUNE/SEL knob until Personalization
Name is highlighted. Press the knob once to
access the Edit Name screen.
3. Use the alpha-numeric keypad at the bottom of the
screen. Turn the TUNE/SEL knob to scroll through
the available letters, numbers and symbols.
Press the knob to select the highlighted character.
As each character is selected, it will appear on the
screen and the system will advance one character
to the right. If you make a mistake, press the
Backspace reconfigurable key to erase the last
character entered. You can then re-enter another
character. If you want to completely erase the entire
name, press the Delete reconfigurable key.
If you prefer lower case letters, press the Lower
reconfigurable key. The reconfigurable key will then
change to Upper. Press the Upper reconfigurable
key to change the letters back to upper case.
4. Repeat Step 3 until the name entry is complete.
You can enter up to 26 characters.
5. Press the OK reconfigurable key when the name is
complete to save it.
The name you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
5-3