Table of Contents
Advertisement
Useful adjustment settings
Power Control
Power Control setting allows you to save energy.
Power Control for AV source
No Signal Off
When set to "Enable", the power will automatically shut
down if no signal inputs for 15 minutes.
Press MENU and the MENU screen displays.
1
Press c / d to select "Option".
2
• Power control menu displays.
Press a / b to select "Power Control", and
3
then press ENTER.
Press a / b to select "No Signal Off", and then
4
press ENTER.
Press a / b to select "Enable", and then press
5
ENTER.
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• "Disable" is factory preset value.
• When a TV programme fi nishes, and the TV receives signal
input, this function may not operate.
No Operation Off
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
Press MENU and the MENU screen displays.
1
Press c / d to select "Option".
2
• Power control menu displays.
Press a / b to select "Power Control", and
3
then press ENTER.
Press a / b to select "No Operation Off", and
4
then press ENTER.
Press a / b to select "Enable", and then press
5
ENTER.
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• "Disable" is factory preset value.
Power Control for PC source
Power Management
When set, the power will automatically shut down if no
signal is input for a certain time.
Press MENU and the MENU screen displays.
1
Press c / d to select "Option".
2
• Power control menu displays.
Press a / b to select "Power Control", and
3
then press ENTER.
Press a / b to select "Power Management",
4
and then press ENTER.
Press a / b to select "Mode1" or "Mode2",
5
and then press ENTER.
Off
Mode1
Mode2
Selected item
Off
• No power management
• Factory preset value.
Mode1
• If no signal inputs for approximately 8
minutes, the power shuts down.
• Even if you start using the PC and the
signal inputs again, the TV stays off.
• The TV turns on again by pressing
POWER. (See page 13.)
Mode2
• If no signal inputs for approximately 8
seconds, the power shuts down.
• When you start using the PC and the
signal inputs again, the TV turns on.
• The TV turns on again by pressing
POWER. (See page 13.)
NOTE
• If you turn off the power by disconnecting AC cord when
setting "Mode2" in power management, the TV may not
function properly after turning the power on again. In such
case, press POWER on the remote control unit.
• Pressing POWER on the display will have the same result.
Description
35
Advertisement
Chapters
Table of Contents
