Transmitter/Receiver Learn Routine - Viper 350 Plus Installation Manual

Transmitter/Receiver Learn Routine

The system comes with two transmitters that have been taught to it. The
system can store up to four different transmitter codes in memory. Use the
following learn routine to add transmitters to the system or to change button
assignments if desired.
If the system was previously programmed using the 998T Bitwriter, the learn
routine may be locked. If the siren generates one long chirp when attempting
to program the unit, the learn routine is locked and must be unlocked using
the 998T Bitwriter before proceeding.
1.
2.
3.
NOTE: If adding a remote, a button must be taught to the unit in the Channel
1 or Channel 5 position prior to programming other channels.
Press and hold the Valet/Program button once more. The siren will chirp
and the LED will blink the number of times corresponding to the channel
accessed.
27
Open a door. (The GREEN wire, H1/5, or the
VIOLET, H1/7 must be connected.)
Turn the ignition on. (The YELLOW wire, H1/9 must
be con nect ed.)
Select the receiver channel:
Valet/Program button the number of times nec es sary
to access the desired channel.
© 20 0 8 D i re cte d E l ec tro n i cs- Al l ri g ht s res e r v e d.
Press and release the