Programmer Interface, 3-Pin Black Plug; Mounting The Control Center - Viper 350 Plus Installation Manual

Programmer Interface, 3-Pin BLACK Plug

The BLACK three-pin port connection is for programming the unit.
When using the 998T Bitwriter®, it is possible to configure any and
all of the programmable functions. For more information please refer
to the guide packaged with the programmer.

mounting the Control Center

The control center's position should be discussed with the vehicle owner prior
to installation, since it will be visible to to the vehicle's operator.
The best location for the Control Center is centered high on either the front
or rear windshield. For optimal range, the antenna should be mounted verti-
cally. It can be mounted horizontally in relation to the windshield or under the
dashboard away from metal, but range will be diminished. Metallic window
tint can also affect range, so this should be a consideration when determining
the mounting location.
After determining the best mounting location, follow these steps:
1. Clean the mounting area with a quality glass cleaner or alcohol to remove
any dirt or residue.
2. Plug the Control Center cable into the Control Center.
3. Mount the Control Center using the supplied double-sided tape.
4. Route the Control Center cable to the control module and plug it into the
four-pin antenna connector.
13
© 20 0 8 D i re cte d E l ec tro n i cs- Al l ri g ht s res e r v e d.