Viper 3002 Installation Manual page 38

Press and hold the Valet/Program button once more. The siren will chirp and the LED will blink
the number of times corresponding to the channel that is accessed.
Valet Step
1
2
3
4
5
6
7
8
9
10
11
*NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.
4. P P r r e e s s s s t t h h e e t t r r a a n n s s m m i i t t t t e e r r b b u u t t t t o o n n : : While holding the Valet/Program button, press
the button from the transmitter that you wish to assign to the selected channel.
The unit will chirp indicating successful programming. It is not possible to
teach a transmitter button to the system more than once.
C C h h a a n n n n e e l l # # 1 1 1 1 : : If any button from a known transmitter is programmed to Channel 11, all trans-
mitters will be erased from memory and the system features will revert to the default settings. This
is useful in cases where one of the customer's transmitters is lost or stolen. This will erase any lost
or stolen transmitters from the system's memory. It can also be used to start from scratch if the
transmitter buttons were programmed incorrectly.
5. R R e e l l e e a a s s e e . . Once the code is learned, the Valet/Program button can be released.
To exit the learn routine:
One long chirp indicates that Learn Routine has been exited. Learn Routine will be exited if any of
the following occurs:
34
Function
Auto/Learn Standard
Lock/Arm/Panic On/Panic Off
Unlock/Disarm/Panic Off
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Arm/Disarm/Panic
Panic Only
Delete All Transmitters
Wire Color
RED/WHITE
WHITE/BLUE
VIOLET/BLACK
WHITE/BLACK
GRAY/BLACK
© 2006
Directed Electronics, Inc.