Viper 3002 Installation Manual page 37

3-11 CHANNEL 6 VALIDITY (ON)/LATCHED/LATCHED, RESET WITH WITH
IGNITION/30-SECOND/60-SECOND/90-SECOND TIMED: Refer to Feature 3-5.
3-12 CHANNEL 6 LINKING (NONE)/ARM, DISARM, BOTH: See Feature 3-6.
3-13 PARKING LIGHT SUPERVISION (ON)/PARKING LIGHT SUPERVISION (OFF): When
programmed ON the parking lights will illuminate for 30-seconds after disarming the system, or turning
off the ignition.
3-14 IGNITION CONTROLLED 2ND UNLOCK (PROGRESSIVE)/IGNITION CONTROLLED
2ND UNLOCK (IMMEDIATE - WITH FIRST UNLOCK): When Progressive 2
2 nd unlock activates after the 1
time as the 1 unlock.
st
Transmitter/Receiver Learn Routine
The system comes with two transmitters (two 1-way remotes on the non 2 way pieces) that have
been taught to it. The system can store up to four different transmitter codes in memory. Use the
following learn routine to add transmitters to the system or to change button assignments if desired.
If the system was previously programmed using the 998T Bitwriter
If the siren generates one long chirp when attempting to program the unit, the learn routine is locked
and must be unlocked using the 998T Bitwriter
1. O O p p e e n n a a d d o o o o r r . . (The GREEN wire, H1/5, or the VIOLET, H1/6 must be connected.)
T T u u r r n n t t h h e e i i g g n n i i t t i i o o n n o o n n . . (The YELLOW wire, H1/9 must be connected.)
2.
S S e e l l e e c c t t t t h h e e r r e e c c e e i i v v e e r r c c h h a a n n n n e e l l : : Press and release the Valet/Program button the number of
3.
times necessary to access the desired channel.
N N O O T T E E : : If adding a remote, a button must be taught to the unit in the Channel 1 or Channel 4 position
prior to programming other channels.
2006
©
Directed Electronics
st unlock. When Immediate is ON the 2
before proceeding.
®
unlock is ON the
nd
nd unlock occurs at the same
, the learn routine may be locked.
®
33