Viper 3002 Installation Manual page 26

wire. This can be done using the status output of a Directed Electronics remote engine starting unit
as shown in the following diagram:
TO OPTIONAL HOOD/
TRUNK PINS OR SENSORS
(OPTIONAL) REMOTE
START UNIT
System Features Learn Routine
The System Features Learn Routine dictates how the unit operates. Due to the number of steps,
they have been broken up into three menus. It is possible to access and change any of the feature
settings using the Valet/Program button. However, this process can be greatly simplified by using
the 998T Bitwriter . Any of the settings can be changed and then assigned to a particular trans-
®
mitter, up to four, a feature called Owner Recognition. Each time that particular transmitter is used
to disarm the system, the assigned feature settings will be recalled. Owner Recognition is only
possible when programming the unit via the 998T Bitwriter
If the system was previously programmed using the 998T Bitwriter
locked. If the siren generates one long chirp when attempting to program the unit, the learn routine
is locked and must be unlocked using the 998T Bitwriter
1. O O p p e e n n a a d d o o o o r r . . (The H1/8 GREEN wire or the H1/6 VIOLET wire must be
connected.)
2. I I g g n n i i t t i i o o n n . . Turn the ignition on, then back off: (The H1/4 YELLOW wire must
be connected.)
3. S S e e l l e e c c t t a a M M e e n n u u . . Press and HOLD the Valet/Program button: (The
Valet/Program button must be plugged into the blue port.) After three seconds
the siren will chirp once indicating entry to the Basic Features Menu #1. If this
is the menu you wish to access, release the button and go on to Step 4. If the
button is not released, you will jump to the Advanced Features Menu #2 and
22
BLUE WIRE H1/7
ZONE 1 INPUT
1N4004 DIODE
.
®
, the learn routine may be
®
.
®
© 2006
CONTROL UNIT
BLUE (-) STATUS
OUTPUT
Directed Electronics, Inc.