Linksys
Data - Workgroup Bridge Screen
Workgroup Bridge Status
Status
Enable or disable Workgroup Bridge function
Before configuring Workgroup Bridge, make
sure all devices in Workgroup Bridge have
the following identical settings
•
•
•
•
Infrastructure Client Interface
SSID
Enter the name of the SSID to which
Workgroup Bridge will connect Click Site
Survey button to choose from the list
Workgroup Bridge must connect to a remote
access point
Remote MAC Address
Normally, Workgroup Bridge connects to a
remote access point by matching SSID When
multiple remote access points have the
same SSID,Workgroup Bridge can connect to
different remote access points
Optional: You can specify the MAC address of
the remote access point to limit Workgroup
Bridge's connection to a specific remote
access point The format is xx:xx:xx:xx:xx:xx
Security Mode
Select the desired mode from the list
•
•
•
Radio
IEEE 802 11 Mode
Channel Bandwidth
Channel (Auto is not recommended)
Disabled
WPA-Personal
WPA2-Personal
Advanced Settings
Configure advanced parameters of the wireless radio
Figure 31: Advanced Settings
CHAPTER 2 Access Point Setup
24