Gr297N Setup - Sapido GR297n User Manual

A: Force your NIC to 10Mbps or half duplex mode, and turn off the "Auto-negotiate"
feature of your NIC as a temporary measure. (Please look at the Network Control
Panel, in your Ethernet Adapter's Advanced Properties tab.)
4. Q: Why can't I connect to the Web Configuration?
A: you can remove the proxy server settings in your web browser.
6.5 Setup
GR297N
1. Q: Why does GR297N 's setup page shut down unexpectedly?
A: If one of the pages appears incompletely in GR297N 's setup pages, please click on
Logout item on the Main Menu before shutting it down. Don't keep it working. Then,
close Internet browser and open it again for going back to the previous page.
2. Q: I don't know how to configure DHCP.
A: DHCP is commonly used in the large local network. It allows you to manage and
distribute IP addresses from 2 to 254 throughout your local network via GR297N .
Without DHCP, you would have to configure each computer separately. It's very
troublesome. Please Open Internet browser > Input 192.168.1.1 in the website
blank field > Select DHCP Server under the IP Config Menu. For more information,
please refer to 3.3.2 (Router Mode) or 4.3.1 (AP Mode).
3. Q: How do I upgrade the firmware of GR297N ?
A: Periodically, a new Flash Code is available for GR297N on your product supplier's
website. Ideally, you should update GR297N 's Flash Code using Firmware
Upgrade on the System Management menu of GR297N Settings.
4. Q: Why is that I can ping to outside hosts, but cannot access Internet websites?
A: Check the DNS server settings on your PC. You should get the DNS servers settings
from your ISP. If your PC is running a DHCP client, remove any DNS IP address
setting. As the router assign the DNS settings to the DHCP-client-enabled PC.
5. Q: GR297N couldn't save the setting after click on Apply button?
A: GR297N will start to run after the setting finished applying, but the setting isn't written
into memory. Here we suggest if you want to make sure the setting would be written
into memory, please reboot the device via Reboot under System Management
directory.
http://www.sapido.com.tw/
97
User Manual v1. 0.0