Table of Contents
Advertisement
& &
Assembling
• To assure that assembly is carried out properly, make sure to read these instructions before you begin the assembly. Please keep these instructions
close at hand, so you can refer to them whenever you need.
• To move the piano, lift it carefully—all the while keeping it level.
• Be careful not to pinch your hands or drop this unit on your foot during assembly or transport.
• Make sure to enlist the help of at least one other person when assembling this unit and moving it to a diff erent location.
• Make sure to keep screws and any other small parts in a safe location that is out of the reach of small children, so such small parts won't accidentally get swallowed.
• All screws should be tightened provisionally fi rst, then tightened later. To tighten a screw provisionally, screw it in until about half of its length is no longer visible. Do not use
an electric screwdriver when tightly securing the screws. Otherwise, you risk stripping the threads.
* The screwdriver needed to perform the assembly is not supplied. You'll need to have ready a Phillips screwdriver that matches the size of the screws.
* After fi rmly tightening all the screws, place the unit at a location that is level and sure to remain stable. The unit must never be placed on top of deep-pile carpet. Otherwise, you risk
causing damage to the pedals due to instability and unnecessary movement.
* The surface of the piano unit and the stand are very delicate; handle with care to avoid scratching them.
* Do not place the piano unit directly on the fl oor. Doing so will damage the bottom panel case and the connectors and holders on the bottom of the piano.
Copyright© 2011 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
Parts Check
1
4
3
1. Assembly Procedure
* At fi rst, assemble the entire stand in a temporary fashion, without really
tightening the screws . Then, after checking the overall alignment of the
boards (and gently shifting certain parts where necessary), go around and
tightly fasten each of the screws .
* If necessary, spread out a blanket or similar material to prevent the stand or
fl oor from being scratched during assembly .
* Be careful not to pinch the pedal cord during assembly .
1.
As shown in the illustration, place the left and right side
boards on the pedal board so that the metal brackets are on
the inside, and fasten them provisionally using screws
(M5 x 40 mm) .
2.
Firmly tighten the screws
tightened provisionally in step 1 .
* When attaching the pedal board, do not allow any gap to remain between the
side board and pedal board when the pieces are assembled .
Side board
Side
board
A
Screw
x 2
Leave the pedal
cord extended
62
Stand Assembly
1
Side Board (left)
2
Side Board (right)
3
Pedal Board
4
Rear Board
2
* You will also need to have a Phillips screwdriver (size: #2).
(four locations) that you
A
Don't allow
a gap!
A
Screw
x 2
A
B
C
D
3.
With the help of another person, raise the left and right side
boards to an upright position .
* Take care that the pedal boards are not twisted .
A
4.
Loosen the screws attached to the left and right side boards
approximately three turns, so that they protrude about
5 mm, as shown in the illustration .
Screw (M5 × 40 mm) x 4
Screw (M5 × 20 mm) x 6
Screw (M4 × 16 mm) x 2
Headphone Hook x 1
Space
5 mm
Advertisement
Table of Contents
