System Software Update Procedure - Roland V-Drums TD-6V Service Notes

SYSTEM SOFTWARE UPDATE
PROCEDURE
Required items
• TD-6V Update Disk SET (P/No.17041438)
• SMF-compatible sequencer(ex.:XP-50/60/80, MC-50/80 etc)
Procedure
1.
Connect the SMF player's MIDI OUT connector to the TD-6V's MIDI IN
connector.
2.
Turn the power on while holding down [EDIT]+[STOP] button, and you
will enter Update Mode. [EDIT] will light.
* If you make a mistake in the order of the following procedure, the TD-6V will
start up in its normal mode.
3.
Continue holding [STOP], release [EDIT], and press [KIT] button.
[KIT] will light.
4.
Continue holding [KIT], release [STOP], and press [SONG] button.
When [KIT] and [REC] light, release the buttons.
If a FlashID error occurs, [CLICK] will light.
If you then press any of the buttons, the TD-6V will start up in normal
mode.
5.
When [KIT]+[REC] go dark and [PLAY] lights, play back the Update
Disks in the correct order.
During the update, the TD-6V will operate as follows.
..5-1 While receiving data, [PART MUTE] will light.
..5-2 While writing data, [REC] will light.
..5-3 When writing is completed and the unit is waiting to receive data,
[PLAY] will light
Each time a SMF is received, operations 5-1 -- 5-3 will be repeated.
6.
When the final disk has finished playing, [SONG] will blink, indicating
that the update process has ended successfully.
When the last block of flash ROM has been received and written, it will be
determined that writing has been completed for all blocks.
Error displays
[CLICK] Flash memory ID code is wrong.
[EDIT], [KIT] Failed to erase Flash memory.
[EDIT], [PLAY] SMF reception error.
[EDIT], [REC] Flash memory writing error.
[EDIT], [CLICK] Following the update, the checksum of the entire
Flash memory differs from the checksum of the update disk.
All dark SMF is invalid.
TD-6V
15