Hunter Set & Save 44155c Installation And Operation Manual page 41

3. Span setting mode – allows you to adjust
the system ON/OFF cycle rate. The default
setting is 2 (the system cycles ON or OFF
o o
when the temperature is within 1 F (0.5 C)
above and below the set temperature.) The
span setting can be adjusted if your system is
cycling too fast or too slowly.
Up Down
Press and hold both the and buttons
Up
until the word SPAN appears. Use the or
Down
button to adjust the span setting.
(Up will increase your cycle time by allowing the system
to run longer; Down will decrease your cycle time by
causing the system to run for a shorter length of time.)
HEAT
Span settings remain the same for and
COOL
system settings. When batteries are
RESET
installed, or the unit is , the span cycle
will revert to 2.
41