Cleaning Your Floors - Bissell Crosswave Cordless Max Deluxe 2593 Series Manual

Cleaning Your Floors

Go to support.BISSELL.com for how-to videos and tips for cleaning stuck-on messes,
excessively dirty or muddy floors, and more!
Mode
Power
1.
Press the power button
ON. Press the mode button to
switch between Hard Floor and
Area Rug Modes.
Area Rug Mode dispenses
double the solution as Hard
Floor Mode. Before cleaning
rugs, check the manufacturer's
tag and test an inconspicuous
spot for colorfastness. Don't
use on silk or delicate rugs.
4.
To clean, hold the solution
spray trigger to apply solution
on forward and backward
passes.
Sanitizing Hard Floors
Please read "DIRECTIONS FOR USE" on Hard Floor Sanitize label. Use on hard nonporous floors only.
1.
Remove visible soil before
cleaning. Hold trigger down to
apply solution on to the floor.
ATTENTION
rugs. Stalling the brush may result in premature belt failure.
8 BISSELL.com
2.
Recline the machine to start
the brush roll spinning. Stand
the machine upright to stop
the brush roll spinning.
5.
To dry floors faster, release
the trigger and make a second
pass without dispensing
solution.
2.
Allow formula to remain wet
on the floor for five minutes.
Do not overwet carpet or hardwood floors. Be careful not to run over loose objects or edges of area
5m
10s
3.
Before each use, hold the
solution spray trigger for 10
seconds to prime the system
with cleaning solution.
LED lights illuminate when
holding the trigger. Bubbles
will appear in the brush roll
window when the solution is
flowing.
6.
Turn OFF the machine by
pressing the power button ( ).
3.
With the spray trigger
released, make forward and
backward passes to extract
solution.