Cleaning Your Floors; Sanitising Hard Floors - Bissell CROSSWAVE HYDROSTEAM Manual

Cleaning Your Floors

Note:
Before cleaning area rugs, check the manufacturer's tag and test an inconspicuous spot on the
rug for colourfastness.. Don't use on silk or delicate rugs.
1. Plug machine into a properly
grounded outlet. Press power
button to turn machine ON and
OFF. When powered ON, starts
in SteamWash mode.
4. Before each use, hold the
solution spray trigger for 10
seconds to wet the brush roll.
Note: Bubbles will appear in
brush roll window when solution
is flowing. Water on floor during
steam cleaning is normal.

Sanitising Hard Floors

Please read the Hard Floor Sanitise formula label prior to each use. Use on hard nonporous floors only.
1. Follow steps above to
remove surface dirt and debris.
To sanitise: Hold the trigger to
apply solution to floor.
2. Press the mode button to
switch between modes. See
page 6 for cleaning mode
information. Mode selection
appears on the foot display.
If you chose SteamWash™,
wait 30 seconds for it to warm
up. The steam ready light will
illuminate.
5.
Hold the trigger to
dispense formula for all
cleaning modes and to
dispense formula plus steam
in SteamWash mode.
the machine back and forth to
clean floors.
5 min
2. Allow floor to remain
visibly wet with formula for
five minutes. May require
additional wet passes.
3. Recline the machine to
start the brush roll spinning.
When the machine is standing
upright, brush roll will not spin.
6. To dry floor, release the
trigger to stop dispensing
solution and steam. Make
forward and backward passes
Move to suction up excess water.
3. With the trigger released,
move machine back and forth
to extract solution.
global.BISSELL.com 7