Cleaning Your Hard Floors - Bissell CROSSWAVE 2203 Series User Manual

Cleaning Your Hard Floors

NOTE: Before you begin, plug the machine into a properly grounded outlet.
1
To start cleaning your
hard floors, install either
the multi-surface brush
roll (can be used on both
hard floors and area
rugs) or the wood floor
brush roll. Then, select
the HARD FLOOR button
to turn the machine on
in the hard floor setting.
Once the setting is
selected, the dry vacuum
will turn on. To turn OFF,
press the HARD FLOOR
setting a second time.
3
Before each use, hold
the solution spray
trigger for 10 seconds to
prime the system with
cleaning solution. LED
lights illuminate when
holding the trigger.
NOTE: When solution
is flowing, you will see
bubbles forming at the
edges of the brush roll
window.
4
To clean, hold the solution
spray trigger to apply
solution on both forward and
backward passes.
NOTE: Hold machine over
stuck on messes while holding
the trigger for best results.
2
Recline the body of the machine
backward to start the brush roll spinning.
To stop the brush roll spinning, you will
need to stand the machine upright.
5
For overly challenging
and stuck-on messes
on your hard floors,
activate the RUG
mode and hold your
CrossWave™ over the
mess.
Using short passes while
holding the trigger
allows the multi-surface
brush to go to work.
www.BISSELL.com
7