Unpacking, Repacking, Returning, Transporting, And Storing - Siemens 7SR45 Manual

First Steps

1.1 Unpacking, Repacking, Returning, Transporting, and Storing

1.1 Unpacking, Repacking, Returning, Transporting, and Storing
Unpacking a Device
Check the packaging for external transport damage. Damaged packing may indicate that the devices
²
inside have also sustained damage.
Unpack devices carefully; do not use force.
²
Check the devices via a reception control to ensure they are in perfect mechanical condition.
²
Check the enclosed accessories against the delivery note to make sure everything is complete.
²
Keep the packing in case the devices must be stored or transported elsewhere.
²
Repacking a Device
If you store devices after reception control, they must be packed in appropriate storage packaging.
²
If the device is to be transported, pack it in transport packaging.
²
Enclose the accessories supplied and the test certificate in the package with the device.
²
NOTE
i
i
Devices are tested prior to delivery. The test certificate is a component of the devices.
Devices are packed on site in a way that meets the requirements of standard ISO 2248.
Returning a Device
In order to return the device to the Siemens factory or any Siemens location, contact the customer
²
support center and follow the instructions specified by them.
NOTE
i
i
Do not transport the device when it is activated. Before transportation, ensure that the device is not in the
battery power mode and protective film is inserted between the battery clip and battery.
Fit the battery cover again and screw it to the housing before transportation.
Storing a Device
Only store devices on which you have carried out an incoming inspection. The incoming inspection is
²
described in the Operating manual.
7SR45 devices must be stored in rooms, which are clean and dry. Devices or associated replacement
²
modules must be stored at a temperature of -25 °C to +70 °C.
To retain the battery life during the transportation and storage, Siemens recommends maintaining the
²
permissible temperature range from -20 °C to +45 °C.
The relative humidity must be at a level where condensed water and ice are prevented from forming.
²
If the device has been in storage for more than 2 years, connect it to an auxiliary voltage for 1 to 2 days.
²
This action will cause the electrolytic capacitors to form on the printed circuit board assemblies again.
Do not transport the device when it is activated. Before transportation, ensure that the device is not in
the battery power mode and paper strip is inserted between the battery clip and battery.
14 Reyrolle, Operating, Manual
C53000-B7040-C101-1, Edition 08.2020