Table of Contents
Advertisement
Connection
6.2 Connecting the sensor box
Close the door
1. Turn the rotary disconnection device
The sensor box power supply is switched off.
2. Close the sensor box door.
3. To switch on the power supply of the sensor box, turn the rotary disconnection device
the "On" position.
6.2
Connecting the sensor box
Connect the sensor box at the motor to the power supply and to the IPC.
Note
Carefully observe the five safety rules (Page 8) when performing any work.
Note
Only route the LAN cable in protected areas
Only route the LAN cable in areas where access is protected to secure against unauthorized
access and manipulation.
Note
Terminal diagram
The terminal diagram for the sensor box is attached to the inside of the housing door and in
the Appendix (Page 71).
The following diagram shows the connections in the sensor box for the CE version of the
connectivity module:
26
②
into the "Off" position.
①
into
Operating Instructions, 06/2020
Advertisement
Table of Contents
