1. Follow the procedure in
2. Remove the
base
cover.
3. Disconnect the battery cable from the connector on the system board.
4. Remove the
WLAN
card.
5. Remove the
WWAN
card.
6. Remove the
display
assembly.
7. To remove the display bezel:
a. Use a plastic scribe to loosen the bottom edge of the display [1].
b. Loosen the tabs on the edges of the display [2].
NOTE:
Adhesive is used to secure the display bezel to the display panel.
8. Remove the display bezel from the display assembly.
Installing display bezel (nontouch)
NOTE:
The display bezel installation procedure is applicable only for nontouch display configuration.
1. Place the display bezel on the display assembly.
2. Press the edges of the display bezel until it clicks onto the display assembly.
NOTE:
Adhesive is used to secure the display bezel to the display panel.
3. Install the
display
assembly.
4. Install the
WLAN
card.
5. Install the
WWAN
card.
6. Connect the battery cable to the connector on the system board.
7. Install the
base
cover.
8. Follow the procedure in
Nontouch display panel
Removing the display panel (nontouch)
NOTE:
The display panel removal procedure is applicable only for nontouch display configuration.
34
Disassembly and reassembly
Before working inside your
After working inside your
computer.
computer.