CAUTION:
Avoid pulling the cable as it would result in breaking the cable connector. Instead, use a scribe
to push the edges of the cable connector to release the LED cable.
b. Remove the M2.0 x 3.0 screw that secures the LED board to the computer [2].
c. Lift the LED board from the computer [3].
Installing LED board
1. Insert the LED board into the slot on the computer.
2. Tighten the M2.0 x 3.0 screw to secure the LED board.
3. Connect the LED cable to the system board.
4. Connect the battery cable to the connector on the system board.
5. Install the
base
cover.
6. Follow the procedure in
Smart card module
Removing smart card cage
1. Follow the procedure in
2. Remove the
base
cover.
3. Disconnect the battery cable from the connector on the system board.
4. Remove the
PCIe SSD card
5. To disconnect the smart card cable:
24
Disassembly and reassembly
After working inside your
Before working inside your
.
computer.
computer.