Mazda MX-30 2022 Owner's Manual Leaflet page 415

Refer to the Replacing Windshield
Wiper Blades (page 6-15) section
for the procedure on how to move
the windshield wiper blades to the
service position.
Contamination of either the
windshield or the blades with foreign
matter can reduce wiper effectiveness.
Common sources are insects, tree sap,
and hot wax treatments used by some
commercial car washes.
If the blades are not wiping properly,
clean the window and blades with a
good cleaner or mild detergent; then
rinse thoroughly with clean water.
Repeat if necessary.
▼ Replacing Windshield Wiper
Blades
When the wipers no longer clean well,
the blades are probably worn or
cracked.
Replace them.
CAUTION
To prevent damaging a windshield
wiper blade, wiper arm, or the hood,
perform the following procedure.
Before lifting the windshield wiper
blades off the windshield, always
move them to the service position.
When putting the windshield
wiper blades back on the
windshield, make sure that they
are in the service position before
switching the power switch ON
and operating the windshield
wipers.
Replace with Mazda genuine wiper
blades. If they are replaced with
wiper blades other than a Mazda
genuine product, they may not wipe
with the same efficiency as the
genuine product.
Owner Maintenance
To prevent damage to the wiper
arms and other components, do not
try to sweep the wiper arm by hand.
Do not bend the blade rubber
unnecessarily when replacing it.
Otherwise, the metal stiffener in the
blade may deform and the
windshield wiper operation may be
adversely affected.
Do not hold a wiper blade by its end
when raising the wiper arm.
Otherwise, the part may deform and
the wiping performance may lower.
Forcefully lowering the wiper arms
could damage the wiper arm and
blade, and may scratch or crack the
windshield.
NOTE
You can replace the wiper blades
yourself, however you cannot replace
the wiper arms.
If you want to replace the wiper arms,
consult an Authorized Mazda Dealer.
Replace the wiper blades using the
following procedure.
1. Move the wipers to the service
positions using the following
procedure.
a) Switch the power switch ON.
b) Switch the power switch OFF.
c) Press up the wiper switch to the
MIST position 2 times within 30
seconds after switching the
power switch OFF.
When the procedure is
completed, the wipers operate
and they stop at the service
positions.
2. Raise the wiper arms.
3. Slide the blade component in the
direction of the arrow while
pressing the wiper arm tab to
Maintenance and Care
6-15