Mazda MX-30 2022 Owner's Manual Leaflet page 271

There is a problem with the stop hold control function.

Setting the vehicle speed
1. Press the TJA switch to turn the system on.
2. Accelerate the vehicle until it reaches the desired speed using the accelerator
pedal and press the RES switch up (SET+) or down (SET-) to set the speed.
NOTE
When the system is turned on, the TJA standby indication (white) turns on and the

TJA display indication is displayed on the multi-information display and the active
driving display.
When the vehicle speed is set, the set vehicle speed is displayed on the displays

and the TJA standby indication (white) changes to the TJA set indication (green)
The minimum speed setting is 30 km/h (19 mph).

When the TJA switch is pressed while the Mazda Radar Cruise Control with Stop &

Go function (MRCC with Stop & Go function) system is operating, the MRCC with
Stop & Go function switches to the TJA. In addition, when the MRCC switch is
pressed while the TJA is operating, the TJA switches to the MRCC with Stop & Go
function.
Setting the distance between vehicles
The distance between vehicles is set to a shorter distance by pressing the CANCEL
switch down, and to a longer distance by pressing the CANCEL switch up. The
distance between vehicles can be set to 4 levels: Long, medium, short, and
extremely short distance.
The distance between vehicles increases or decreases depending on the vehicle
speed.
Distance-between-vehicles
guideline
(at 80 km/h (50 mph) vehicle
speed)
Long (about 50 m (164 ft))
Medium (about 40 m (131 ft))
Indication on multi-information
display
i-ACTIVSENSE
Indication on display
Indication on active driving dis-
When Driving
*1
play
4-123