Mounting The Connectivity Module - Siemens Simotics Connect 400 Operating Instructions Manual

Mounting and installation

5.2 Mounting the connectivity module

3. Apply the adhesive to the recommended locations on the inner side of the mounting bracket.
Carefully ensure that no adhesive enters the threads for the fastening screws.
Note
Handling the adhesive
Follow the handling instructions on the packaging of the adhesive.
The recommended adhesives set quickly. Therefore handle them quickly.
4. Place the mounting bracket on the motor cooling ribs. The short arm of the mounting bracket
must be in complete contact with a cooling rib. The long mounting bracket arm must be in
contact with one or several edges of the cooling ribs.
5. Press the mounting bracket onto the motor cooling ribs using your hand.
6. Allow the adhesive applied to the mounting bracket to dry. Carefully comply with the usage
instructions provided on the adhesive package.
7. Allow the adhesive to completely dry.
5.2 Mounting the connectivity module
For easier handling while mounting on the motor, we recommend first screwing the
connectivity module to the mounting bracket. The battery is not contacted in the delivered
condition.
20
SIMOTICS CONNECT 400
Operating Instructions, 08/2021, A5E50161952B AE