Table of Contents
Advertisement
OPERATION MODE
•
Press the MENU button and the display shows each option in sequence, then
press ENTER and the LCD will show modes for you to choose.
•
Use the UP/DOWN buttons to set the desired inversion, then press ENTER to
confirm.
USER CONFIGURATION
To set the DMX channel configuration:
•
Press the MENU button until it shows "ChNd", then press ENTER and the LCD will
show "16CH" or "21CH".
•
Use the UP/DOWN buttons to set the desired channel mode and press ENTER to
confirm.
•
Choose a unit to function as the Master, then select one of the modes as an auto
running programme.
•
Finally, chain the units together using DMX cable, the required speed mode can be
the Master one's programming. The other units are set to the same DMX Address.
Set Master/Slave Mode:
•
Press MODE until "SlNd" is displayed,
•
Press ENTER to chose "master", "slave 1" or "Slave 2" modes, Press ENTER to
set the mode. This mode will allow you to link up to 32 units together without a
controller.
•
Use standard DMX cables to daisy chain your units together via the DMX
connector on the rear of the units.
•
Proper performance it may be necessary to use a terminator at the last fixture.
AUTO Speed Mode:
•
This mode allows a single unit to run one of four factory installed programme in a
range of 9 speeds.
Sound Mode:
•
Press MODE until "SeNs" is displayed.
Press ENTER to choose sensitivity of response by use of the UP and DOWN
buttons. Press ENTER to set the desired level.
To set the PAN to inverting or non-inverting:
Press the MODE button until it shows "PaN", then press ENTER and the LCD will
•
show "OFF" or "ON".
•
Use the UP/DOWN buttons to set the desired mode and press ENTER to confirm.
To set the Tilt to inverting or non-inverting:
•
Press the MODE button until it shows "TiLt", then press ENTER and the LCD will
show "OFF" or "ON".
•
Use the UP/DOWN buttons to set the desired mode and press ENTER to confirm.
LED Mode:
Press MODE until "Led" is displayed.
•
Press ENTER and then use the UP/DOWN buttons to set "ON" or "OFF" The LED
display will turn off after a time unless a button is pressed.
SERVICE FUNCTIONS
To reset the unit:
Press the MENU button until the display shows "rSet". Press ENTER to confirm.
•
To test the operating functions:
Press MENU until "teSt" is displayed and the sequece will commence.
•
8
Advertisement
Table of Contents
