Table of Contents
Advertisement
Please read these instructions carefully before use and retain for future
reference.
IMPORTANT SAFETY INFORMATION
•
When using electrical appliances basic safety precautions should always be
followed.
•
Check the product before use for any damage. Should you notice any damage on
the cable or casing, do not use.
•
Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the product to the mains power supply.
•
Keep this product away from rain and moisture.
•
Caution: Never look directly into the light source.
•
Always disconnect from the mains when the product is not in use or before
cleaning.
•
Make sure there are no flammable materials close to the unit while operating.
•
Do not operate or store in an environment of high humidity or where moisture may
enter the product as this can reduce insulation and lead to electric shock.
•
Do not connect the product to a dimmer pack.
•
Never carry the fixture solely by its head.
•
The LED lamps in this product are not replaceable.
•
Refer all servicing and repair work to qualified personnel.
Safety Information for Installation and Operation:
•
When installing, make sure that the product is not exposed to extreme heat,
moisture or dust.
•
If you're using a smoke machine, make sure that the product is never exposed to
the direct smoke jet and is installed at least 0.5m away.
•
The maximum ambient temperature is 40°C (104°F). Do not operate the product in
temperatures higher than this.
•
The relative humidity must not exceed 50% with an ambient temperature of 45°C.
•
The minimum distance between the light-output and the illuminated surface must
be more than 0.5m.
•
This product is allowed to be installed via a mounting bracket. In order to have
sufficient ventilation, leave 50cm of free space around the device. Ensure no
ventilation slots are blocked.
•
A secondary means of suspension must be provided, such that in the event of a
failure of the primary suspension, no part of the luminaire can fall.
•
The housing must not touch any surrounding surfaces or objects.
•
The operator must make sure that safety related matters are observed and that
the installation is approved by a qualified installer before taking into operation for
the first time.
•
Always disconnect from the power source before servicing or replacing the fuse
and be sure to replace with the same fuse size and type.
2
Advertisement
Table of Contents
