Table of Contents
Advertisement
Advanced Operation
Operating Your Radio
Tri-Watch
Tri-Watch gives you one (1) button access to scan the three (3) locations of
most importance to you. Channel 16 will always be one (1) of the scanned
locations. The other two (2) locations will be stored in the radio. They can
be edited and/or recalled for future engagements of Tri-Watch mode.
NOTE
The radio must be squelched for tri-watch to function.
See page 31 for squelch procedure.
To Program Or Edit The Tri-Watch Locations:
Tri-Watch Button
1. Press and hold the Tri-Watch button for three (3)
seconds. The Tri-Watch and Memory icons on
the LCD will be turned On.
2. Press the Channel Up or Channel Down button
to move to the channel you want to enter into
tri-watch location one (1).
3. Press the Tri-Watch button. You will hear a
Tri-Watch and Memory Icons
two (2) beep confirmation signal.
4. Press the Channel Up or Channel Down button
to move to the channel you want to enter into
tri-watch location two (2).
5. Press the Tri-Watch button. You will hear a
two (2) beep confirmation signal and the Memory
icon will disappear from the LCD. The radio will
immediately engage tri-watch (see page 39
Channel Up/Down Buttons
for further details).
38 English
Advanced Operation
Operating Your Radio
To Enter Tri-Watch Mode:
Tri-Watch Button
1. From Standby mode, press the Tri-Watch button.
The Tri-Watch icon will appear on the LCD and the radio
will scan among Channel 16, tri-watch location one (1),
and tri-watch location two (2). A signal on any one (1)
of the three (3) locations will stop the scan for ten (10)
seconds to allow you to listen to the traffic on that location.
To Exit Tri-Watch Mode:
Tri-Watch Mode
1. Press the Tri-Watch button.
The icon will disappear from the LCD and the
radio will return to Standby mode status.
During Tri-Watch (while receiving an incoming
transmission), You Can Choose From The Following:
a. Press the Talk button to remain on that
tri-watch location and return to Standby mode.
b. Press the Channel Up or Channel Down button
to resume scanning tri-watch locations.
If you do not press any buttons within ten (10)
seconds, your radio will automatically resume
scanning tri-watch locations.
During Tri-Watch (while not receiving a transmission),
Talk or Channel Up/Down
You Can Choose From The Following:
a. Press the Talk button to communicate on the
last tri-watch location scanned and return to
Standby mode.
b. Press the Channel Up or Channel Down button
a
b
to change scan direction.
Nothing comes close to a Cobra
®
39
Advertisement
Table of Contents
