Cobra MRHH400 Owner's Manual page 24

Cobra mrhh400 marine radio: owners manual
Table of Contents

Advertisement

Advanced Operation
Operating Your Radio
Memory Location Scan
Memory Location Scan
During Memory Location Scan, the radio will rapidly switch
68
69
from memory location to memory location. Whenever any
activity is detected, the radio will stop the scan for ten (10)
71
79
seconds to allow you to listen briefly on that memory
A
location. It will then continue to scan unless you switch
72
78
out of the Scan mode.
A
NOTE
The radio must be squelched for the memory location
scan to function. See page 31 for squelch procedure.
NOTE
If there are fewer than two (2) memory locations
programmed in the radio, the memory location
scan option will not be available. To program at
least two (2) memory locations, see page 40.
42 English
Advanced Operation
Operating Your Radio
To Enter Memory Location Scan:
Memory Button
1. From Standby mode, press the Memory button.
2. Press the Scan button.
The radio will immediately begin to scan the channels you
programmed into the memory. The Scan and Memory icons
Scan Button
will show on the LCD.
To Exit Memory Location Scan:
1. From Memory Location Scan mode, press the Scan
button. This will return the radio to Memory mode on the
last scanned memory location.
Memory Scan Mode
2. Press the Memory button to return to Standby mode on
the last channel shown before entering memory scan.
During Memory Location Scan (while receiving
an incoming transmission), You Can Choose From
The Following:
a. Press the Talk button to remain on that memory location
and end scanning. This will return the radio to Standby
mode.
b. Press the Channel Up or Channel Down button to
resume scanning memory locations.
If you do not press any buttons within ten (10) seconds,
Talk or Channel Up/Down
your radio will automatically resume scanning memory
locations.
During Memory Location Scan (while not receiving a
transmission), You Can Choose From The Following:
a. Press the Talk button to communicate on the last
a
memory location scanned and return to Standby mode.
b
b. Press the Channel Up or Channel Down button to change
scan direction.
Nothing comes close to a Cobra
®
43

Advertisement

Table of Contents
loading

Table of Contents