Dry Ironing; Shot Of Steam - Rowenta DW9220 Manual

1103909885 DW9220 DW9225 D1_110x220mm 26/02/13 08:57 Page4
IMPORTANT The iron takes longer to cool down than to heat up. We recommend that
you start with fabrics to be ironed at a low temperature. For mixed fabrics set the
temperature for the most delicate fabric. At the first heating-up of the cold iron please
wait until the Thermostat indicator goes off the second time. Then the set temperature
is reached and you can begin ironing.
TIP: Always spray starch onto the reverse side of the fabric to be ironed.
3 • Dry ironing
Set the iron on for an ironing without steam, ideal for delicates or perfect finishes.
4 • Steam ironing
Your iron is equipped with the Steamforce technology an electronic steam pump which
pushes up to 30% more steam into the fabric. The steam quantity and the temperature will
adjust automatically to the selected fabric.
5 • Shot of steam
Press the shot of steam button to generate a powerful jet of steam concentrated at the tip
fig.8 . This precision shot allows steam concentration in the front area to remove stubborn
creases. Wait a few seconds between each shot before pressing the button again.
IMPORTANT Leave an interval of a few seconds between each shot and wait until the
flow of steam has finished before standing the iron on its heel.
6 • Vertical shot of steam
Hold the iron vertically and press the shot of steam button to remove creases from suits, jackets,
skirts, hanging curtains etc.
button again.
IMPORTANT Never direct the steam at persons or animals!
TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning
delicate fabrics.
(*) Depending on model
FABRIC THERMOSTAT
Nylon (Synthetic
fibres, e.g. viscose,
polyester)
silk
wool
cotton
linen
(Autosteam & Steamforce)
(from temperature setting (••) upwards)
(from temperature setting (••) upwards)
fig.9 . Wait a few seconds between each shot before pressing the
4
THERMOSTAT IRONING
INDICATION LABEL
NYLON
SILK
WOOL
COTTON
LINEN