Panasonic EY76A1 Operating Instructions Manual page 11

Hide thumbs Also See for EY76A1:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 8
LED Light
Press the light button and set illumination
condition.
Illuminated
Illuminates by pressing button.
The light turns off when the tool
has not been used for more
than 5 minutes or just after
attaching the battery pack.
Depress the trigger switch and
operate the tool once.
Interlocking trigger
Illuminates while depressing the
trigger switch.
Off
CAUTION:
Do not use it as a substitute for a
regular flashlight, since it does not have
enough brightness.
CAUTION: DO NOT STARE INTO
BEAM.
Use of controls or adjustments or perfor-
mance of procedures other than those
specified herein may result in hazardous
radiation exposure.
Overheat warning
Off
Illuminated:
(normal
Overheat
operation)
(motor)
Indicates operation has been halted due to
motor or battery overheating.
• If the overheating protection feature
activates, allow the tool to cool thorough-
ly (at least 30 minutes). The tool is ready
for use when the overheat warning lamp
goes out.
• Avoid using the tool in a way that causes
the overheating protection feature to
activate repeatedly.
• The performance of the EY9L42 deterio-
Battery Level Indicator
Press the battery level button. It shifts to
Impact power mode when release the
button.
Flashing:
Overheat
(battery)
[Battery Pack]
For Appropriate Use of
Battery Pack [Fig.7]
• For optimum battery life, store the Li-ion
• When operating the battery pack, make
- 11 -
rates significantly at and below 10°C due
to work conditions and other factors.
NOTE:
The indicator will not show the battery
level even the button is pressed in the
following cases.
• The main unit is powered off.
• Just after attaching the battery pack
• The main unit or battery level button is
not operated for approx. five minutes.
Press the battery level button again
after depressing the trigger switch.
Indicator
3 lamps
illuminated
2 lamps
illuminated
One lamp
illuminated
3 lamps
flashing
battery pack following use without
charging it.
sure the work place is well ventilated.
EN
Battery status
Charged
enough
Approx. 60%
remaining
Battery level is
low.
Empty

Advertisement

Table of Contents
loading

Table of Contents