Advertisement
2. Disassembly SOP
Preparation before disassemble
1. Clean the room for disassemble
2. Identify the area for monitor
3. Check the position that the monitors be placed and the quantity of the monitor; prepare the area for
material flow; according to the actual condition plan the disassemble layout
4. Prepare the implement, equipment, material as bellow:
1) Working table
2) Screw-driver
3) Glove
4) Cleaning cloth
5) ESD protection
6) U3818DW Curve Sponge Jig
Item
1
Picture
Operation
1. Place monitor head
on U3818DW curve
sponge jig
2. Carefully slide and
remove the I/O cover
from the monitor
3. Disconnect the
cables from the
monitor and slide
them out through the
cable-management
slot on the stand riser
4. Press and hold the
stand release button
5. Lift the stand up and
away from the
monitor
- 6 -
Tool
Notes
U3818DW
Panel and whole
monitor head
Curve
must be placed
Sponge
on U3818DW
Jig
curve sponge jig
to avoid panel
damage.
It is not allowed
to place the
front side of
panel and
monitor head on
a flat surface
Advertisement
