Siemens SIREMOBIL Iso-C Installation And Setting Instructions page 4

4
Programming
•
Switch the system on.
•
Simultaneously press keys [CTRL] and [U] on the memory keyboard.


•
Configure the video recorder output for monitor A.
(Perform the configuration for monitor B only by special customer request).
•
End the "user menu".
•
Switch the SIREMOBIL Iso-C off and on again to activate the new configuration.
Function check
•
Set the video recorder to record.
•
With Fluoro, move the collimator blades slightly into the field.
Release fluoro for approximately 20 seconds.
•
Stop the video recorder and rewind the tape.
•
Replay the scene.
Concluding work
•
Switch OFF the SIREMOBIL.
•
Check the protective conductor function using the protective conductor meter 44 15 899
RV. Refer also to TI 236 / ARTD - 002.731.17...
Changes to previous version
Page 3: Paragraph "Line voltage cable" changed.
TD SD 24 / Arnold
SIREMOBIL Iso-C
Installing and setting the Video Recorder
This calls the "User Setup menu" for Memoskop.
Register 3
TD SD 24/ Schlee
SPR2-230.033.03
Rev. 03 10.99
SMS Iselin / Ristau
Page 4 of 4
TD SD 24 Medical Engineering
1
1
1
1
Siemens AG