Satellite Radio Mode - Clarion CZ301 Owner's Manual & Installation Manual

Satellite Radio Mode

Listeners can subscribe to SIRIUS
on the Web by visiting www.sirius.com, or
by calling (888) 539-SIRIUS. Customers
should have their SIRIUS ID ready (SIRIUS
ID is located on the SCC1: SIRIUS Connect
Vehicle Tuner, solid separately). Customers
can listen to music samples by tuning to
channel 184.
Accessing satellite radio mode
Press the [SRC /
panel or remote control to switch to the SAT
source.
Displaying the Identification (ID) Code
Before you listen to satellite radio, you must
subscribe to the service using your radio's
identification number. To display the radio
ID, use the [
channel "0". The screen displays the radio ID
where the channel name is usually displayed.
Check SC-C1 SIRIUS Connect
Vehicle TUNER
If SIRIUS tuner is not connected, "NO
TUNER" will appear on the LCD.
Select a band
Press the [BAND] button to change between
three SAT bands (SR1, SR2 and SR3). Each
band stores up to six preset stations.
Select a station
Press the [ ] or [
tune to another station.
Preset mode
Six numbered preset buttons store and recall
stations for each band.
14
® Radio
] button on the front
] tuning button to tune to
] tuning button to
Preset scan
Short press the [PS/AS] button to start
category scanning.
Long press [PS/AS] (1 sec.) to start preset
station scanning for 10 seconds each.
Storing a station
1. Select a band (if needed), then select a
station.
2. Press and hold a preset button (numbers
1-6) on the front panel.
3. The preset number and station is
displayed and highlighted.
Recalling a station
1. Select a band (if needed).
2. Press a front panel preset button
(numbers 1-6) to select the corresponding
stored station.
Category and Channel search
To access Category and Channel Search
mode, press the [BAND] button more than 1
second on the front panel.
1. Rotate the [VOLUME] knob on the panel
to select the desired category.
2. Press the [ ] or [
the channel name.
Direct search
To access Direct Search mode, press the
[MENU] button on the front panel.
1. Rotate the [VOLUME] knob on the panel
to select the desired direct, and press the
knob to confirm the selection.
2. Rotate the [VOLUME] knob on the panel
to select the direct number, and press the
knob to confirm the selection.
PASSWORD
Refer to System Setup page 11.
] button to select