Dip Switch (Sw1) Setting; Dip Switch Position; Parallel Interface Type - Citizen CBM-920II User Manual

7. DIP SWITCH (SW1) SETTING

7.1 DIP Switch Position

DIP switch (SW1) is located at the back of the printer as shown in the figure below.
The polarity and part of the function of the switch differs depending on the interface.
For memory switch setting, refer to "4.9 Setting Memory Switches".
NOTE
Before setting, turn the printer power off.
Do not use edged object, such as a pen, to change the switch.

7.2 Parallel Interface Type

Switch No.
1
2 (920)*
2 (3110)*
3
4
*: Difference may occur in accordance with the emulation set by the memory switch.
After setting DIP switch No. 4 to ON, turning the printer power on with the SEL switch
pressed and held causes the printer enter the Manual memory switch setting mode.
After manual setting mode, be sure to set this switch to OFF.
Function
Character direction
CR command
CR command
RESET in
Memory switch
Serial
ON
1
Parallel
ON
1
OFF
Normal
Ignore CR
CR
Disable
Disable Setting Enable Setting
— 34 —
2 3 4 5 6 7 8
2 3 4
ON Factory Setting
Inverted
CR + LF
LF
Enable
OFF
OFF
OFF
ON
OFF