Advertisement
www.freeservicemanuals.info
RX-8010RBK/ RX-8012RSL
Removing the main board
Prior to performing the following procedure, remove
the top cover, the rear panel and audio board.
1.
Cut off the tie band fixing the harness.
2.
Disconnect the harness from connector CN811 on
the power supply board respectively.
3.
Disconnect the harness from connector CN881 on
the main board.
4.
Remove the four screws I and the two screws J
attaching the main board.
Removing the Heat sink
1.
Remove the two screws L' attaching the heat sink
from the rear side of main board.
2.
Disconnect the connect CN701, CN702, CN703,
CN705 and CN706 on the main board.
3.
Remove the ten screws K and four screws L
attaching the heat sink.
1-6
(See Fig.14)
(See Fig.15 and 16)
Digitized in Heiloo the Netherlands
I
J
J
I
Main
board
CN881
Fig.14
Heat sink
L'
Main board
rear side
Fig.15
K
Heat sink
L
CN702
CN706
Main board
CN705
I
J
CN811
Tie band
I
L'
K
K
L
CN701 CN703
Fig.16
2/17/2019
Not for sale!
Advertisement
