Remington X3 POWER-X Series Manual page 7

INSTRUCTION FOR USE
BEFORE STARTING THE CUT
• Make sure your clipper is operating correctly. Inspect the hair clipper
making sure that it is free from hair and dirt.
• Place a cape around the neck of the person whose hair is being
trimmed or cut.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
• Hold the hair clipper in the palm of one hand and with your thumb
resting firmly on the top of the hair clipper. This grip provides
comfortable cutting control.
TO ATTACH A COMB
• Hold the comb with its teeth upward.
• Align the legs of the comb with the holes in the top
of the clipper on each side of the blade and slide
the legs into the trimmer until they click (Fig A).
• To remove, firmly pull the comb straight up away
from the clipper.
SETTING THE LENGTH OF CUT
• Your clipper comes with two adjustable combs 3 to 13 mm and 14 to
24 mm.
• These provide a length of cut that can be adjusted between 3 and 24
mm in increments of 1 mm.
1.
Select the comb that fits the range of cut you want to achieve.
2.
Fit the comb then rotate the length adjustment dial until the length you
want appears in the length selection window for that comb.
3.
The length setting colour on the wheel matches the length marker
colour on the comb.
4.
For example, if you want a cut length of 20 mm, fit the 14 to 24 mm
comb then turn the dial until 20 appears in the length setting window
for the 14 - 24 mm comb.
5. Use the clipper without any fixed combs for trimming hair close to the
skin.
6.
This will trim hair to 1mm, holding the clipper so the blades are
perpendicular to the skin will trim hair to 0.5mm.
7
m
n
h
A
i
j