Remington X6 POWER-X Series Manual page 9

short you would like your hair to be.
• The comb guide lengths described for use in the steps below are an
example only, if you want a longer or shorter hair cut you will need to
adjust the comb guide lengths to suit your requirements.
Step 1 - Nape Of The Neck
• Use 3mm or 6mm guide comb.
• Hold the hair clipper with the blade teeth pointing upwards. Begin
starting at the centre of the head at the base of the neck.
• Slowly lift the hair clipper, working upwards and outwards through the
hair, trimming just a little at a time.
Step 2 - Back Of The Head
• With the comb set at 12 mm or 18 mm, cut the hair at the back of the
head.
Step 3 - Side Of The Head
• With the comb set at 3 mm or 6 mm, trim sideburns.
• Then change to the longer 9mm guide comb and continue to cut to the
top of the head.
Step 4 - Top Of The Head
• Use the longer length comb attachment and set it to 24 mm or 27 mm
then cut hair on top of the head against the direction in which the hair
normally grows.
• For longer hair on top, use the longer length comb attachment (25 –
35 mm) to achieve the desired style.
• Always work from the back of the head.
Step 5 - The Finishing Touches
• Use the hair clipper without an attachment comb for close trimming
around the base and sides of the neck.
• To produce a clean straight line at the sideburns, reverse the clipper.
Place the reversed hair clipper at right angles to the head, tips of the
blades lightly touching the skin and then work downwards.
9